[jamsat-news:3312] [ans] ANS-266 Special Bulletin - Fox Telemetry Decoder Software Version 1.0 Available for Download

[JoAnne Maenpaa]

AMSAT NEWS SERVICE SPECIAL BULLETIN
ANS-266

In this edition:

* Fox Telemetry Decoder Software Version 1.0 Available for Download

SB SAT @ AMSAT $ANS-266.01
ANS-266 AMSAT News Service Special Bulletin

AMSAT News Service Bulletin 266.01
>From AMSAT HQ KENSINGTON, MD.
September 23, 2015
To All RADIO AMATEURS
BID: $ANS-266.01

Fox Telemetry Decoder Software Version 1.0 Available for Download

Version 1.0 of the FoxTelem software, the Fox Telemetry Decoder is being
released to enable setup, testing, and debugging of your Fox-1A ground
station prior to the launch of the satellite. FoxTelem is used to
demodulate, store and analyze telemetry data from AMSAT's Fox series of Cube
Sats. 

Fox-1 satellites include two telemetry formats:

+ Slow Speed, also called Data Under Voice (DUV) is 200 bps FSK data 
  sent at the same time as the transponder audio. Whenever the trans-
  mitter is on, data is being sent. This happens during beacons and 
  during live QSOs.

+ High Speed is 9600 bps FSK sent instead of the transponder. This is 
  used for data intensive experiments such as the Virginia Tech Camera. 
  This is only active when commanded from the ground. You can recognize 
  High Speed because it sounds like an old school computer modem. 

FoxTelem will receive and store both formats assuming you can feed it audio
that does not have the frequencies below 200 Hz filtered.  For High Speed,
the audio must also extend to include the full 9600bps bandwidth of the FM
signal. For both modes this is best achieved from a Software Defined Radio
or from the 9600 bps packet port of some radios. The FoxTelem User Guide
provides more details.

FoxTelem is supplied as an archive file (.zip on windows, .dmg file on
MacOs, .gzip on Linux). Links for downloading can be found at:
http://www.amsat.org/?page_id=4532
You can unzip the contents and put it in the directory of your choice. Also,
detailed in the User Guide, are instructions to select the sound source and
set received audio levels on your computer.

Until Fox-1A is launched you can confirm everything is working by testing
with test wav file which will be available from:
http://amsat.us/FoxTelem/recordings . Access to the test file is
accomplished by selecting "Load Wav File" from the FoxTelem File menu, then
navigate to the directory where you saved the test wav file. Once you press
the start button the file will play through the decoder.

The FoxTelem page can also be accessed from the main AMSAT web page:
http://www.amsat.org --> Fox Project --> FoxTelem Software for Windows, Mac,
& Linux
The direct link to the page is: http://www.amsat.org/?page_id=4532

[ANS thanks the FoxTelem software team for the above information]

/EX


_______________________________________________
Via the ANS mailing list courtesy of AMSAT-NA
http://www.amsat.org/mailman/listinfo/ans