[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][JAMSAT Home]
[jamsat-bb:14875] AO-40: are the commands received?
JJ1WTK 坂本です
通信途絶の状態にあるAO-40のリカバリー作業について
この数日、AO-40管制局から情報は特にはありません。
ここでは、AO-40のコマンド受信器について amsat-bb上で行われている
質疑応答について紹介します。原文は、最後にまとめて掲載します。
--------
HB9US Wernerからの質問(資料1)
単純な機械的コードによるコマンドを送信しているということだが、そのコマン
ドを、(AO-40が)受信していることは確かだろうか?
受信できるとしても、電圧が極端に下がっていることによって、コマンド受信器
は(正常なときよりも)わずかにずれた周波数を受信している、ということはな
いだろうか?
--------
K0KN, Kyleのコメント(資料2)
私自身は、このアイディアは試してみる価値があると思う。
もし、電圧が下がっていることによってコマンド受信器の感度が低下していると
したら、(通常よりも)強力な信号でアップリンクする必要があるのでは?
機械的コード(によるコマンドの送信)をW5UNに依頼してみては?
W0EEC,Emilyのコメント(資料3)
数日前、私は、amsat-bb上ではなかったが管制チームに同じ質問をした。
そのときの回答は次のとおり。
>コマンド受信機は、BCR(バッテリ充電制御器)から供給される冗長系の
>連続10V電源から電源供給を受けている。だから、バス電圧が10V以上あれば、
>コマンド受信機は正常に動作するはずである。10V以下の場合には、動作が不安
>定になるかもしれないが、私は動作下限電圧は知らない。
>管制チームは、すべてのコマンド受信器のあらゆるアップリンク周波数を
>使って、(AO-40へのコマンドを)試みている。
資料1
----------------------- Original Message -----------------------
From: "Werner H. Berli" <w.h.berli@bluewin.ch>
To: amsat-bb@AMSAT.Org
Date: Wed, 04 Feb 2004 08:42:14 +0100
Subject: [amsat-bb:74950] AO-40: are the commands received?
----
Can we be sure that the simple machinecode commands are actually
received?
Could it be, that the command receiver under extremely low supply
voltage is actually listening on a slightly different frequency?
73
Werner, HB9US
----
資料2
From: "Kyle Yoksh" <yokshs@planetkc.com>
To: <w.h.berli@bluewin.ch>, "amsat-bb" <amsat-bb@AMSAT.Org>
Date: Wed, 4 Feb 2004 09:54:14 -0600
Subject: [amsat-bb:74961] Re: AO-40: are the commands received?
I, myself, think that these ideas are worth a try.
I have been wondering if the command receiver may be less sensitive due to
the low voltage, thus a more powerful uplink signal would be required?
Anyone asked W5UN to try the machine codes? :-)
Kyle Yoksh
K0KN
Olathe, Kansas
Amsat# 35249
----
資料3
From: Emily Clarke <w0eec@AMSAT.Org>
To: "Kyle Yoksh" <yokshs@planetkc.com>,<w.h.berli@bluewin.ch>
"amsat-bb" <amsat-bb@AMSAT.Org>
Date: Wed, 04 Feb 2004 09:45:17 -0800
Subject: [amsat-bb:74965] Command Receivers ( was AO-40: are the commands received?)
----
Several days ago I asked the same question of the command team off-list and
here was the reply.
>the command receivers are running from a redundant 10V continous
>power supply from the BCR. So as long as the Bus voltage is above
>10V, it should be fine. Below 10V it may get somewhat unstable,
>but I don't now what the limit was..
>Our command stations are indeed trying all the command receivers
>and also vary the uplink frequency..
73,
Emily
---------------------------------
W0EEC - CM87tm
-------------
JAMSAT BB Mailing List
http://www.jamsat.or.jp/infoserv/mlist.html