[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[jamsat-bb:4885] UO-36 operations (38k4 downlink, IFD, MSPE, TNC3)


JJ1WTK 坂本です

amsat-bbで、G7UPN Chirsが UO-36の38.4kbpsダウンリンク運用や
38k4の受信方法についてヒントを書いていましたので、紹介します。

UO-36(UoSAT-12)は現在38.4kbpsFSKのダウンリンクで運用しています。
周波数は437.025MHzです。このダウンリンクは、サレー上空では常時Onに
していますので、ヨーロッパ各局はアクセスできるでしょう。ただし、
UO-36の電力事情により、その他の地域でも利用できるように常時Onに
する余裕はありません。

このため、私はユーザーが短時間に限ってダウンリンクをOnにできる
ようにソフトウェアのテストを進めています。これができれば、
ユーザーが使わない大部分の時間はダウンリンクをOffにできるので、
パワーを節約できますし、地上局が衛星の送信機をOnにしたいとき、
ダウンリンクをOnにするまえに衛星のバッテリーのパワーや
システムの状態をチェックできます。もし、バッテリーの電圧が
低すぎたり、いくつかの条件が折り合わなければ、ダウンリンクは
Onになりません。

このソフトウェアは、現在 VK5HI、W0SL、W4SMらの手によってテスト
されています。そのため、USAやVK/ZLの上空では衛星のダウンリンクが
聞こえることがあるでしょう。もし、テストがうまくいけば、MSPEの
バージョンアップという形で一般に公開します。

ところで、UO-36の38k4ダウンリンクを受信している人たちの多くが、
Symek社の製品を使っていることと思います。"IFD"モジュールは、比較的
安く、無線機の内部に組み込めるタイプのもので、高速なデータ通信を
受信するのに向いています。詳しい情報は www.symek.com にあります。

38k4のダウンリンクを受信するためには、TNCとPCの間の通信速度を38k4以上に
する必要があります。そうでなければ、データを失うことになります。
MSPEのアップデート版では、Symek社のTNC3と組み合わせて使えるようになります。
TNC3は、1.6Mb/sまでの転送速度が可能で、内部モデムは2種類まで組み込む
ことができます。Symekの製品であるTNC3は、現在UO-36の38k4ダウンリンクを受
信している人たちの間ではもっともポピュラーなものです。

UO-36 の運用情報は次のとおりです
アップリンク周波数   149.600
ダウンリンク周波数   437.025
ブロードキャストコールサイン  UO121-11
アップリンクの変調速度  9600
ダウンリンクの変調速度  38400

ダウンリンクの周波数は、将来的には437.400MHzに移ることになっています。

73,
Chris G7UPN / ZL2TPO

以下は原文です。
Forwarded by JJ1WTK, Kazu Sakamoto <jj1wtk@jamsat.or.jp>
---------------- Original message follows ----------------
 From: Chris Jackson <c.jackson@eim.surrey.ac.uk>
 To: "'amsat-bb@amsat.org'" <amsat-bb@AMSAT.Org>
 Date: Mon, 13 Dec 1999 11:08:37 -0000
 Subject: [jamsat-amsat-bb:27512] UO-36 operations
--

UO-36 (UoSAT-12) is currently being operated at 38k4 on 437.025MHz.
Currently, this downlink is always switched on over Surrey, so should be
accessible to operators in Europe.  Due to the limited power on UO-36, it is
not possible to have this downlink on permanently over all areas.

For this reason, I am currently testing some software that will allow
stations to switch the downlink on for a short period.  This ensures that
the downlink is OFF for most of the time when stations are not using the
satellite, and therefore saves power.  Additionally, when the groundstation
requests the transmitter be switched on, it performs some checks on the
available power and status of various systems before deciding to switch the
downlink on.  If the battery voltage is low, or if a small number of other
conditions are not met, the transmitter will not be switched on.

This software is currently being tested by VK5HI, W0SL and W4SM.  Thus, the
downlink should be available at various times over the USA, and VK/ZL.  Once
we are happy with the operation of the software, I will release it for
general use in the form of an updated version of MSPE.

Most people currently downloading at 38k4 on UO-36 are using Symek
equipment.  The "IFD" module is relatively low cost and can be fitted inside
most radios for reception of high data rates.  Further information can be
found at www.symek.com.

For receiving 38k4 downlink, you should ensure that your data rate between
the TNC and the PC is higher than 38k4 or you will loose data.  The updated
version of MSPE will also support the Symek TNC3 which can run at data rates
up to 1.6Mb/s and can support 2 internal modems - again, this unit from
Symek is quite popular with stations currently receiving 38k4 on UO-36.

UO-36 operating information -:
Uplink frequency	149.600
Downlink Frequency	437.025
Broadcast callsign	UO121-11
Uplink data rate		9600
Downlink data rate	38400

Note that the downlink frequency may change to 437.400 in the future.

73,
Chris G7UPN / ZL2TPO

----
Via the amsat-bb mailing list at AMSAT.ORG courtesy of AMSAT-NA.
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org